Search This Blog

Valuable Tips For Laptop Screen Repair Houston

By Lelia Hall


The best option with a broken notebook display unit is popping a new one which is quite easier than you may think. Though it is best to contact a PC technician for laptop screen repair Houston, these tips will also help. Indeed, the sound of your laptop VDU cracking as it hits the floor is more distressing than even a tooth ache. Though risky, with just with a screwdriver you can replace the display unit yourself saving bundle.

Note that this procedure is usually for the laptops with a LED backlit LCD. With each model, the internal hardware calls for specific steps in regard to display replacement. You should not try fixing it yourself, but you should contact the manufacturer, the dealer or a professional to get it repaired under any available warranty.

The display backlight keeps showing some flickers and afterwards shuts down after a few minutes of use and trying to start all over again does not come back at all. You can still see some faint images, and then you find out that the problem could be the inverter(the small board that supplies power to the backlight). This board cost around a hundred dollars, hence consider replacing it first. This may still not solve the problem, so finally consider checking the backlight.

If you happen to see some gibberish lines, you will be required to connect to an exterior monitor. Afterwards switch the display and observe. If the problem still shows on the external monitor, then consider checking on the motherboard or the video circuitry.

Now you will be required to replace the VDU. Just find the bezel screws and remove them. With a lot of care, carefully check the rubber cushions that cover the bezel to reveal all the screws holding the screen in place. It is required to remove and examine the current display unit prior ordering new one. Doing so, you can view what causes the problem directly from the VDU.

You will need the screen number for a purchase of a direct match replacement. Be sure to remove the power cable, as well as the battery, prior to any operation in regard to removing the VDU. The tool you may need to use include a small bit screwdriver, very little flat screwdriver, as well as a knife.

Locate all the screws, and remove them. Using the knife, carefully check the corner of each rubber cover around the screen. Anything you remove should be placed somewhere safe. Remove the bezel once you have secured all the screws that hold it. Gently remove the bezel away from the LCD. For the bottom centers on the LCD, you can carefully work out your fingers amid the bezel and the screen. If the bezel does no pop loose with a little force, check to make sure that all the screws are out.

The fourth step involves testing the new screen for functionality. This will only be possible after reinstalling the bezel. Before you can attach the bezel, it's better if you first test the new panel. Here, just reconnect the battery and then the power cable. Turn on your laptop, if the VDU functionality is good, go on with bezel reattachment. Many of the external screws, as well as rubber cushions, should be placed back. The laptop VDU repair is successively completed now, but it's always better to cross check with a professional.




About the Author:



0 comments:

Post a Comment

 
Powered By Blogger | Portal Design By Trik-tips Blog © 2009 | Resolution: 1024x768px | Best View: Firefox | Top